Brand: Bosch Range: AeroTwin Dimensions: 340mm / 13.5″ Product codes: 3397006827/ AP13U This is a single blade unit Wiper Compatibility List VEHICLE YEAR FROM YEAR TO (DRIVER) (PASSENGER) Fiat 500 2007/07 – AP24U AP13U Ford Ka II 2010/11 – AP24U AP13U Hyundai ix20 2010/10 – AP26U AP13U Kia Venga 2009/12 – AP26U AP13U Nissan Pulsar 2014/07 – AP26U AP13U Nissan Sentra 2014/09 – AP26U AP13U Nissan Tiida 2015/05 – AP26U AP13U Opel Mokka 2012/09 – AP26U AP13U Renault Captur 2003/01 2016/02 AP26U AP13U Renault Clio IV 2012/05 – AP26U AP13U Renault Clio IV Grandtour 2012/11 – AP26U AP13U Renault Twingo III 2014/09 – AP20U AP13U Renault ZOE 2013/01 – AR24U AP13U Smart Forfour, Fortwo 2014/11 – AP20U AP13U AeroTwin Range Aerotwin: Maximum performance flat wiper blades Aerotwin is always dependable even at high speeds: Perfect visibility is guaranteed by the aerodynamic design – whatever the weather conditions. The tailor-made spring strip ensures top-quality wiper action over the full area. Aerotwin advantages at a glance Optimum wiper performance without any smears Features particularly quiet operation on wet and almost dry windshields Increased service life, even in extreme heat or cold Provides optimum visibility thanks to its aerodynamic design, even at high speeds Original-equipment quality Can be retrofitted very easily and fitted in the blink of an eye “Tested on your car” by comprehensive vehicle-specific tests When should you get new wiper blades? This depends on how often you use your windscreen wipers and the different conditions your car is exposed to. Rubber deteriorates in hot, cold, wet or dry weather, so we recommend changing your wipers every 12 months, or if you experience any of the following: Juddering on the screen Noise or squeaking across both dry and wet screens The blade feels worn down or has notches when you run a finger down it Your blade leaves streaks or unwiped areas on the windscreen How to fit wiper blades Step One: Lift up your wiper arm from the screen Step Two: Unclip the old wiper blade, either by sliding the blade out of the clip system or pulling it gently off the arm. Be very careful not to let the arm snap back onto the windscreen, as this could cause damage. Step Three: Clip your new wiper blade onto the arm, taking care to ensure there’s a firm ‘clicking’ noise or feeling. Give it a wiggle to make sure it’s secure. Step Four: Replace the arm and blade slowly onto the windscreen. If it doesn’t look straight, or the whole blade doesn’t sit on the glass, then it hasn’t been fitted correctly. Repeat the process for the other three (or more) wiper blades on your car.
